GL300 Quick Start Guide

GL300

Our GL300 devices come ready to use. It is important to make sure that your device is fully charged before each use, refer to the Charging section below for more information.

If you bought your device from Mastrack.com:

  • It will arrive already activated, and your username and a temporary password will have been emailed to you.
  • Simply switch the device to "on" and it will begin tracking as soon as it registers motion.

If you bought the device through one of our vendors, such as Amazon.com:

  • Simply go to our website, Mastrack.com, and click the "Activate" tab near the top right of the screen.
  • After purchasing a service plan to go with your device, and creating a unique username, an email will be sent to the email address you provided containing a copy of your username and a temporary password.
  • Use these to log in to your account, and when prompted, enter your device's serial number.
  • Your device will then be activated, and it will receive its programming automatically as soon as your car is switched on, and begin reporting immediately.
  • Simply switch the device to "on" and it will begin tracking as soon as it registers motion.

Turning on/off

Press and hold power button located on top of the device for about 1 second. Lights will begin blinking, starting with the Red Power light.

To turn off, press and hold the power button until you see the red light flash rapidly, then let go.

The device will take several seconds to turn off with a good GPS signal, and up to 1 minute to turn off with no/poor GPS signal, as it will attempt to report before turning off.

The device will automatically turn on if plugged into the extended battery or charger, and will automatically turn off if unplugged. It will not turn off when plugged into either of these unless it is unplugged, in which case it will turn off instantly without reporting.


GL300 - Placement

Vehical Optimal Locations

  • Glove Box
  • Trunk
  • Mounted Securely to the under carriage
  • Mounted inside the vehicle under plastic panels

Other

  • In a jacket pocket
  • In a zippered backpack
  • Within a package or box
  • In a purse or briefcase

GL300 - Charging

Use the provided 5V charger to charge the device. DO NOT use any other charger. Use of another charger WILL void your warranty and likely damage your device.

When charging, the Red light will blink rapidly.

Once fully charged, the Red light will become solid.

Total charge time is approximately 5 hours.